Quomodo evadere phenomenum cipiorum ferrorum cadentem in processione partium precisiorum

Stamping parts processing plants sometimes exhibit the phenomenon of iron chips falling off during the edge trimming of precision stamping parts, which seriously affects the quality of products and reduces productivity. This not only causes a lot of losses to the manufacturer but also delays the delivery time to customers. So why does this situation occur? Exploramus sequentes punctos:

1. The trimming edge of precision stamping parts is not straight during processing.

2. Partia pulsata non conparant faciem fusilae;

3. Unreasonable blade clearance in precision stamping parts processing;

4. Poor smooth of stamping blade edge; 5. Secondary interception with waste knife;

6. Insufficient difficile extinguentis in partibus pretiosis processionis;

7. Profunditudo mordis maculi nimis profunda est.

8. Unreasonable design of precision stamping parts molds, etc.

When manufacturers can pay attention to these reasons, they can mostly avoid product crushing caused by iron filings.

This article is from EMAR Mold Co., Ltd. For more EMAR related information, please click on www.sjt-ic.com,