CNC First-Piece Check for Thread Fit and Length

A specified thread-fit check and a usable-length check answer different questions. When both appear on the drawing, record them separately. Hold the first piece for review if either check fails.

What to confirm on the drawing

Use the approved drawing revision. Check the complete thread designation, the required fit and the minimum usable thread length if specified. Identify where the length starts and ends. If there is a chamfer, incomplete thread or runout, confirm how the drawing treats that area. Agree whether the checks take place before or after any specified finish.

What to put in the inspection record

Drawing featureWhat to confirmWhat to record
Thread fitThread designation and agreed inspection methodDrawing item, gauge identifier where applicable, and pass or fail result
Usable thread lengthStart and end points, minimum usable length, and any excluded areasDrawing item, method, actual reading and units, acceptance limit, and result
Shoulder location, if specifiedReference face and axial dimension on the drawingDrawing item, reference face, measuring instrument, actual reading and result

Add the part number, drawing revision, sample or lot identifier, and inspection date to the report header. Use the same item numbers on the drawing and the report. If measurement traceability is required, confirm what documentation is needed and whether the method is suitable for the tolerance being checked. Xometry's sample inspection documents · NIST's guidance on measurement traceability

What to do if a check fails

Keep the first piece on hold and identify the drawing item that failed. Confirm the revision, measurement stage, reference points and method before agreeing how to proceed. If an approved correction affects the threaded area, repeat the fit and usable-length checks as specified in the inspection plan. Keep the original and repeat results distinguishable. Record the disposition and who approved it before proceeding, where first-piece approval is required.

What to send with a quote request

Include the drawing revision, thread designation, fitting or mating-part details where relevant, required usable length, and the surface finish if it affects acceptance. Identify the features that must be included in the inspection report and whether first-piece approval is required. CNC turning for small stepped parts · Contact EMAR

​