Five axis CNC machining precautions and characteristics sharing

1. Before processing, each program must strictly confirm whether the tool and program are compatible.

2. When installing the tool, it is necessary to confirm whether the length of the tool and the selected blade are suitable.

3. Do not open the door during machine operation to avoid flying knives or scattering workpieces.

4. If the tool is found during the machining process, it is necessary for the operator to immediately stop, such as pressing the "emergency stop" button or "reset button" or setting the "feed rate" to zero.

5. It is necessary to adhere to the same area of the same workpiece in order to ensure the accuracy of the CNC Machining center operation rules during tool connection.

If excessive machining allowance is found during the machining process, it is necessary to use "single segment" or "pause" to clear the X, Y, and Z values, then manually mill and shake back Zero "allows it to operate on its own.

7. During the operation process, the operator must not leave the machine or regularly check the operating status of the machine. If it is necessary to detach halfway, it is necessary to designate relevant personnel for inspection.

8. Before spraying with a light knife, the aluminum slag inside the machine tool should be cleaned to avoid oil absorption.

9. When rough machining, try to blow with air and spray oil in the light cutting program.

10. After the workpiece is taken off the machine, it should be cleaned and deburred in a timely manner.

11. At the end of work, it is necessary for operators to give timely and accurate instructions to ensure that subsequent processing can proceed normally.

12. Before shutting down, ensure that the tool magazine is in its original position and the XYZ axes are stopped in the center position, then close the power supply and main power supply on the machine operation panel.

13. In the event of a thunderstorm, it is necessary to immediately shut off the power and suspend work.